Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
228 Configuration Manual, 06/2016, C79000-G8976-C252-11
Call up the command with the following parameters:
show etherchannel [[channel-group-number]
{detail|load-balance|port|port-channel|summary|protocol}]
The parameters have the following meaning:
Number of the Channel-Group
Detailed display of the settings
Shows which load balancing method is enabled
Information on the Etherchannel port
Information on the Port-Channel
Brief overview of the settings of a Channel-Group
Specification of the protocol set for a Channel-Group
If you do not select any parameters from the parameter list, the settings of all channels will
be displayed in detail.
The Etherchannel settings are displayed.
show interfaces etherchannel
Description
This command shows the interface-specific information for a port channel.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show interfaces[<interface-type><interface-id>]etherchannel
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
To Next Page
Loading...
Need help?
General