Siemens SCALANCE XM-400 Configuration Manual

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
66 Configuration Manual, 06/2016, C79000-G8976-C252-11
3.1.1.9
show interfaces
Description
This command shows the status and the configuration of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interfaces
[{
[<interface-type><interface-id>]
[{description|stormcontrol|flowcontrol|status}]
|
{vlan<vlan-id(1-4094)>}
|
port-channel<port-channel-id(1-8)>}
|
private-vlan mapping
]
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
description
Shows the description of the interface
-
stormcontrol
Shows the storm control settings -
flowcontrol
Shows the flow control settings
-
status
Shows the status of the interface. -
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 ... 4094
port-channel
Keyword for a port channel connection
-
port-channel-id
Number of the addressed port channel
1 … 8
private-vlan map-
ping
Shows from which secondary PVLANs
the IP interface of the primary PVLAN
is reachable.
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameters from the parameter list, the status and configuration of
all available interfaces will be displayed.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English