Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.8 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
503
Result
The limit is deleted.
Further notes
You define the max. number of Join-messages on the device with the ipv6 mld join
ratelimit
command.
You can display the status of this function and other information with the
show ipv6 mld
snooping globals
command.
8.8.2.3
ipv6 mld snooping
Description
With this command, you enable MLD snooping on the device or on the required VLAN.
For MLD snooping to work, you need to enable the function globally and in the VLANs. In the
Global configuration mode, enable MLD snooping on the device or globally. To enable MLD
snooping on the required VLAN, execute the command in the VLAN configuration mode.
Requirement
● GMRP is disabled.
● You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 mld snooping
Result
MLD snooping is enabled.
Further notes
You disable GMRP with the no grmp command.
You disable MLD snooping with the
no ipv6 mld snooping command.
You display the setting and other information with the
show ipv6 mld snooping and show ipv6
mld snooping globals
commands.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English