Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
729
With this command, you delete the filter for a tag.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Call up the command with the following parameters:
no match tag <value (1-0xffffff)>
The parameter has the following meaning:
Value of the tag 1 ... 0xffffff
You can enter the value in decimal or
The filter for a tag is deleted.
You create the filter for a tag with the match tag command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
To Next Page
Loading...
Need help?
General