Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.9 NAT (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
742 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
no ip nat {idle | {tcp | udp } timeout
The parameters have the following meaning:
Parameter
Description
Range of values / note
idle
Keyword for the time period of a xxxx con-
nection
-
tcp
Keyword for the time period of a TCP con-
nection
-
udp
Keyword for the time period of a UDP con-
nection
-
Result
The time periods are reset.
Further notes
You delete the periods of time with the ip nat timeout command.
You display the current configuration with the command.
9.9.3
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
9.9.3.1
ip nat
Description
With this command, you enable NAT for the IP interface.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English