Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
608 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameter has the following meaning:
Parameter
Description
Range of values / note
metric
Value for the metric 1 ... 65535
Default: 1
Result
The metric is specified.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You can reset the metric to the default with the
no ipv6 ospf metric command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.8
no ipv6 ospf metric
Description
With this command, you reset the metric back to the default value.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf metric
Result
The metric is reset.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English