Siemens SCALANCE XM-400 - Show Ip Pim Mroute; Ip Pim Clear Counters

Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
760 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.10.1.10
show ip pim mroute
Description
With this command, you display the PIM routing table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip pim mroute [ {proxy | {group-address | source-address } summary } ]
The parameters have the following meaning:
Parameter
Description
Range of values / note
proxy
Shows the proxy table.
-
group-address
Address of the multicast group
-
source-address
Source IP address of the multicast
packet
Enter a valid IPv4 multicast ad-
dress.
summary
Shows a summary of the entries. -
Result
The current PIM routing table is displayed.
9.10.2
ip pim clear counters
Description
This command, you reset the counters of an interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#