Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
602 Configuration Manual, 06/2016, C79000-G8976-C252-11
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
9.3.4.1
ipv6 ospf area
Description
With this command, you enable OSPFv3 on the interface. The interface is assigned to an
area.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● The router ID is configured.
● OSPFv3 routing is activated.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 ospf area <IPv4-Address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
IPv4-Address
IPv4 address of the interface with which the
OSPFv3 protocol instance is connected.
specify the IP address in the
IPv4 address format.
x.x.x.x
Result
The interface is assigned to an area.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English