Siemens SCALANCE XM-400 - Start; Stop

Security and authentication
11.5 Port Access Control List Locked Ports
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
859
11.5.4.1
start
Description
With this command, you start automatic learning. During automatic learning, the aging timer
is disabled for all learned addresses.
Requirement
You are in the AUTOLEARN mode.
The command prompt is as follows:
cli(config-auto-learn)#
Syntax
Call the command without parameters:
start
Result
The learned MAC addresses are entered in the "port database" with the aging time 0. (The
entries are NOT deleted when the "MAC Address Aging Time" expires).
Further notes
You stop automatic learning with the stop command.
11.5.4.2
stop
Description
With this command, you stop automatic learning and convert all learned MAC addresses to
static entries.
Requirement
You are in the AUTOLEARN mode.
The command prompt is as follows:
cli(config-auto-learn)#
Syntax
Call the command without parameters:
stop