Siemens SCALANCE XM-400 - No Private-Vlan Mapping

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
202 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
private-vlan mapping [{add | remove}] <vlan-list>
The parameters have the following meaning:
Parameter
Description
Range of values / note
add
Adds secondary PVLANs.
-
remove
Removes secondary PVLANs. -
vlan-list
VLAN ID of the secondary PVLAN Separate the PVLANs with commas
if you specify several PVLANs.
Result
The IP interface of the primary PVLAN can be reached from the selected secondary
PVLANs.
Further notes
You delete the link between secondary PVLANs and the IP interface of the primary PVLAN
with the command
no private-vlan mapping.
You display this setting with the
show interfaces command with the private-vlan mapping
parameter.
6.1.3.4
no private-vlan mapping
Description
With this command you delete the link between secondary PVLANs and the IP interface of
the primary PVLAN with the command .
Requirement
● The interface is configured as an IP interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no private-vlan mapping