Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
866 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface
Keyword for a an interface description
-
interface-type
Type or speed of the interface Enter a valid interface.
interface-id
Module no. and port no. of the interface
statistics inter-
face
Keyword for the display of the statisti-
cal data of the dot1x Authenticator for
an interface
-
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The dot1x information is displayed.
11.7.1.2
show dot1x guest-vlan mac-info
Description
This command displays which MAC address and which port are assigned to a guest VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show dot1x guest-vlan mac-info
Result
A list with guest VLAN, MAC address and port is displayed.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English