Siemens SCALANCE XM-400 - Show Snmp Engineid; Show Snmp Filter

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
386 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameters:
show snmp community
Result
The details of the configured SNMP communities are displayed.
7.8.1.3
show snmp engineID
Description
This command shows the SNMP identification number of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp engineID
Result
The SNMP identification number of the device is displayed.
7.8.1.4
show snmp filter
Description
This command shows the configured SNMP filters.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#