Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
755
Call up the command with the following parameters:
show ip pim interface [vlan <vlan-id(1-4094)>] detail
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all interfaces are displayed.
Detailed settings for PIM are displayed.
You enable PIM globally on the device with the ip pim routing command.
You assign an interface to PIM with the
ip pim command.
show ip pim neighbor
Description
With this command, you display the PIM neighborhood table.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ip pim neighbor [ vlan <vlan-id(1-4094)>]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
To Next Page
Loading...
