Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
249
Syntax
Call up the command with the following parameters:
spanning-tree mst max-hops <value(6-40)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
value
Maximum number of hops that a path
can run through in an MST
6 ... 40
Default: 20
Result
The setting for the maximum number of hops is configured.
Further notes
You can reset the setting for the maximum number of nodes to the default with the no
spanning-tree mst max-hops
command.
You display this setting and other information with the
show spanning tree mst
configuration
command.
6.3.4.7
no spanning-tree mst max-hops
Description
With this command, you reset the maximum number of hops that a path in an MST can run
through to the default value.
The default value is 20.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree mst max-hops
Result
The setting for the maximum number of nodes is reset to the default value.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English