Siemens SCALANCE XM-400 - Commands in the VLAN Configuration Mode; Ip Igmp

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
442 Configuration Manual, 06/2016, C79000-G8976-C252-11
8.2.3
Commands in the VLAN configuration mode
This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
vlan $$$ command to change to this mode.
When doing this, you need to replace the
$$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.
8.2.3.1
ip igmp
Description
With this command, you enable IGMP on an interface.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
ip igmp
Result
IGMP is enabled on the interface.
Further notes
You disable IGMP on an interface with the no ip igmp command.
You display the setting and other information with the
show ip igmp global-config
command.