Siemens SCALANCE XM-400 - No Track Links; Vrrp Virtual-Ping

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
627
9.4.3.6
no track links
Description
With this command, you delete the the number of tracked interfaces.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
no track <group-index> links
The parameter has the following meaning:
Parameter
Description
Range of values / note
group-index
ID of the interface tracking
-
Result
The number of tracked interfaces is deleted.
Further notes
You configure the number of tracked interfaces with the track links command.
You display the configured number of tracked interfaces with the
show vrrp track command.
9.4.3.7
vrrp virtual-ping
Description
With this command, you enable pings to virtual addresses.