Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
704 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter
Description
Range of values / note
default
Default routes are not forwarded.
-
connected
Route information of local subnets is
not forwarded.
-
ospf
No routes learned by OSPF are for-
warded.
-
static
No static routes are forwarded.
-
route-map
Keyword for a route map.
-
name
Name of the route map.
Maximum of 20 characters
Result
In certain cases, forwarding of routing information is disabled.
Further notes
You enable the forwarding with the no redistribute metric command.
You display the setting and other information with the
show ipv6 rip command.
9.7.4
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
Note
These commands are available only with layer 3.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English