Siemens SCALANCE XM-400 - Traceroute

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
80 Configuration Manual, 06/2016, C79000-G8976-C252-11
Parameter
Description
Range of values / note
size
Keyword for the size of the packets
to be transferred
-
value
Packet size 0 … 2080 bytes
Default: 100
anycast
Addressing mode anycast
-
source
Keyword for the sender interface
• VLAN
• source_prefix
-
vlan
Keyword for a VLAN connection
-
id
Number of the addressed VLAN
1 ... 4094
source_prefix
Prefix of the sender
-
timeout
Response wait time
If this time expires, the request is
reported as "timed out".
-
value
Time until timeout 1 ... 100 s
Default: 5
Result
The messages relating to the response of the called node are displayed.
3.1.11
traceroute
Description
With this command you enable the following of the route via which the packet comes to the
requested IP address.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
traceroute {ip <ip-address> | ipv6 <ip6-address>}