Layer 2 management protocols
8.7 Multicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
492 Configuration Manual, 06/2016, C79000-G8976-C252-11
The multicast blocking settings for ports are displayed.
show mac-address-table dynamic multicast
Description
This command shows the table with the dynamic multicast MAC addresses assigned by the
device.
evice does not learn any reserved multicast addresses, see also RFC 5771.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show mac-address-table dynamic multicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>]
[{interface<interface-type><interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a MAC address
Keyword for a an interface description
Enter a valid interface
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
To Next Page
Loading...
