Siemens SCALANCE XM-400 - Show Ip Igmp Groups; Commands in the Global Configuration Mode

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
437
Syntax
Call the command without parameter assignment:
show ip igmp group-list
Result
The list is displayed.
8.2.1.3
show ip igmp groups
Description
With this command, you display the list of joined multicast groups.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ip igmp groups
Result
The list is displayed.
8.2.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.