Siemens SCALANCE XM-400 - Show Ip Ospf Area-Range

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
520 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ip ospf virtual-links
Result
The overview is displayed.
9.2.1.11
show ip ospf area-range
Description
This command shows the grouped address ranges.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip ospf {area-range|summary-address}
The parameters have the following meaning:
Parameter
Description
area-range
Grouped area range.
The address range is created with the "area-range" command.
summary-address
Grouped address range for OSPF.
The address range is created with the "summary-address" command.
Result
The grouped address ranges are displayed.