Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
692 Configuration Manual, 06/2016, C79000-G8976-C252-11
This section describes the commands relevant for working with routing with RIPng.
RIPng (RIP next generation) is only used with IPv6 and is defined in RFC 2080. As with RIP
(IPv4), RIPng is based on the distance vector algorithm of Bellman-Ford.
In contrast to RIPv2, RIPng is activated directly on the interface (VLAN interface / router
port) and not on the entire device.
RIPng uses the UDP port 521 and RIP the UDP port 520.
This section describes commands with which you display various settings.
show ipv6 rip
Description
This command shows the information of the RIP database.
● Routing with RIPng is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ipv6 rip [database]
The parameter has the following meaning:
The information of the RIP database is
-
The information of the RIP database is displayed.
To Next Page
Loading...
Need help?
General