Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
728 Configuration Manual, 06/2016, C79000-G8976-C252-11
With this command, you specify whether or not the routing information for a route map is
filtered based on tags.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Call up the command with the following parameters:
match tag <value (1-0xffffff)>
The parameter has the following meaning:
Value of the tag 1 ... 0xffffff
You can enter the value in decimal or
The filter for a tag is created.
You delete the filter for a tag with the no match tag command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
To Next Page
Loading...
Need help?
General