Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
665
no vrrp compatible-mode
Description
With this command, you disable compatibility with VRRPv2. The VRRP router can only send
and receive VRRP packets of version 3.
Note
This command is available only with layer 3.
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Call up the command with the following parameters:
no vrrp <vrid(1-255)> compatible-mode
The parameter has the following meaning:
The compatibility is disabled.
You configure a VRRP3 interface with the interface command.
You assign IPv4 / IPv6 addresses to a virtual router with the
vrrp associated-ip command.
You enable the compatibility with the
vrrp compatible-mode command.
You can display the status of the function with the
show vrrp3 or with the show vrrp3
interface
command.
To Next Page
Loading...
Need help?
General