Siemens SCALANCE XM-400 - Authorized-Manager Ip-Source

Security and authentication
11.6 Management Access Control List
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
862 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no authorized-manager
Result
The authorized manager is deactivated.
Further notes
You enable the function with the authorized-manager command.
11.6.2.3
authorized-manager ip-source
Description
With this command, you configure the interfaces and protocols via which an authorized
manager is allowed to access the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefixlength(0-32)>}]
[interface[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]]
[vlan<a,b or a-b or a,b,c-d>]
[cpu0]
[service[snmp][telnet][http][https][ssh]]