Siemens SCALANCE XM-400 - Show Unicast-Block Config

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
71
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show traceroute {ip | ipv6 }
The parameters have the following meaning:
Parameter
Description
Range of values / note
ip
The destination is an IPv4 address
-
ipv6
The destination is an IPv6 address -
Result
The route is displayed.
Further notes
You enable the following of the route with the traceroute command.
3.1.1.16
show unicast-block config
Description
This command shows the unicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show unicast-block config [port <interface-type> <interface-id)>]