Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.7 Multicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
491
8.7
Multicast
The commands in this section configure the procedures for handling Multicast frames.
The commands allow the following:
● Configuration of groups
● IGMP/MLD
● GMRP
● Blocking unknown Multicast frames.
With the "show" commands, you can display the configuration data.
8.7.1
The "show" commands
This section describes commands with which you display various settings.
8.7.1.1
show multicast-block config
Description
This command shows the multicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
port
Keyword for a port description
-
interface-type
Type of interface
Enter a valid interface
interface-id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all ports are displayed.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English