Siemens SCALANCE XM-400 - No Track Interface

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
625
9.4.3.4
no track interface
Description
With this command, you delete the tracking of interfaces.
Note
This comma
nd is available only with layer 3.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
no track <group-index> interface { vlan <vlan-id (1-4094)> | <interface-type>
<interface-id> }
The parameters have the following meaning:
Parameter
Description
Range of values / note
group-index
ID of the interface tracking
-
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 … 4094
interface-type
Type of interface
Specify a valid interface.
interface-id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
Interface tracking is deleted.
Further notes
You configure an interface tracking with the track interface command.
You display the configured interface tracking with the
show vrrp track command.