Load control
10.3 Dynamic MAC aging
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
788 Configuration Manual, 06/2016, C79000-G8976-C252-11
You enable the filter with the switchport ingress-filter command.
You can display the status of the ingress filter and other settings with the
show vlan port
config
command.
The section describes commands with which the aging of dynamically learned entries is
configured in a MAC address list.
This section describes commands with which you display various settings.
show mac-address-table aging-time
Description
To ensure that the address entries are up-to-date, MAC addresses are only kept in the
address table for a specified time.
This command shows the time after which the MAC addresses are removed from the
address table.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show mac-address-table aging-time
The time is displayed.
To Next Page
Loading...
Need help?
General