Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
441
Syntax
Call up the command with the following parameters:
ip igmp limit <value(1-4096)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
value
Number of multicast groups
1 ... 4096
Result
The maximum number is defined.
Further notes
You delete the limit for learnable multicast groups on the device with the no ip igmp limit
command.
You display the configured multicast groups with the
show ip igmp global-config command.
8.2.2.6
no ip igmp limit
Description
With this command, you delete the limit for learnable multicast groups on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip igmp limit
Result
The limit is deleted.
Further notes
You define the maximum number of multicast groups that can be learned using IGMP with
the
ip igmp limit command.
You display the configured multicast groups with the
show ip igmp global-config command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English