Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
766 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter
Description
Range of values / note
Group Address
Address of the multicast group for
which the interface will become
RP.
-
Group Mask
Subnet mask that restricts the
multicast band
-
IP address
IP address of the interface that will
become RP
-
Priority
Priority of the interface 0 ... 255
Default: 192
Result
The interface is a candidate for the rendezvous point.
Further notes
You delete RP candidates with the no rp-candidate rp-address command.
You display the interface candidates for rendezvous points with the
show ip pim rp-
candidate
command.
9.10.4.2
no rp-candidate rp-address
Description
With this command, you delete RP candidates.
Requirement
You are in the PIM configuration mode.
The command prompt is as follows:
cli(router-pim)#
Syntax
Call up the command with the following parameters:
no rp-candidate rp-address <Group Address> <Group Mask> <RP address>

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English