Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
238 Configuration Manual, 06/2016, C79000-G8976-C252-11
Shows the counters of the various
-
Shows detailed information about the
spanning tree settings of the interface.
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
The settings of the ports for the spanning tree function are displayed.
show spanning-tree interface layer2-gateway-port
Description
This command shows the settings of Layer 2 Gateway Port (L2GP). For example the priority,
the MAC address and the status of L2GP are displayed.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show spanning-tree interface
[<interface-type><interface-id>]
layer2-gateway-port
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
The settings for Layer 2 Gateway Port (L2GP) are displayed.