Siemens SCALANCE XM-400 Configuration Manual

System time
5.3 SNTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
169
The parameters have the following meaning:
Parameter
Description
Range of values / note
unicast
configures the SNTP client in unicast
mode
Default: unicast enabled
broadcast
configures the SNTP client in broad-
cast mode
Supports only IPv4 addresses
Result
The addressing mode of the SNTP client is configured.
Further notes
You display this setting and other information with the show sntp status command.
You display the settings for the unicast mode with the
show sntp unicast-mode status
command.
You display the settings for the broadcast mode with the
show sntp broadcast-mode status
command.
5.3.3.2
sntp time diff
Description
With this command, you configure the time difference of the system time relative to the UTC
time.
Requirement
● The SNTP server must have started up.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp time diff <(+/-hh:mm)>
The parameter has the following meaning:
Parameter
Description
+
Time zones to the west of the SNTP server time zone
-
Time zones to the east of the SNTP server time zone

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English