Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.5 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
480 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
ring ports <interface-type><interface-id><interface-type><interface-id>
The parameters have the following meaning:
Parameter
Description
interface-type
Specifies the interface type for the first ring port
interface-id
Specifies the number of the interface for the first ring port
interface-type
Specifies the interface type for the second ring port
interface-id
Specifies the number of the interface for the second ring port
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Note
Differing port addresses
The first and second port must be configured on different interfaces.
Result
The ports of the ring redundancy are configured.
8.5.6.2
standby connection-name
Description
With this command, you assign a name to the standby connection on the device.
Requirement
You are in the Redundancy configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call up the command with the following parameters:
standby connection-name <string(32)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
<string(32)>
Name of the connection
max. 32 characters

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English