Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
535
9.2.3.11
compatible rfc1583
Description
With this command, you enable compatibility with RFC 1583. Use the command if you still
have old OSPFv2 routers in operation that are not compatible with RFC 2328.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call the command without parameters:
compatible rfc1583
Result
The compatibility with RFC 1583 is enabled.
Further notes
You disable the compatibility with the no compatible rfc1583 command.
You can display the status of this function and other information with the
show ip
ospf
command.
9.2.3.12
no compatible rfc1583
Description
With this command, you disable compatibility with RFC 1583.
Note
This command is available only with layer 3.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English