Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
623
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
no interface vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN 1 … 4094
interface-id
Module no. and port no. of the interface
Enter a valid interface.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The VRRP interface is deleted.
Further notes
You configure a VRRP interface with the interface command.
You display the status and the configuration of the VRRP interface with the
show vrrp or show
vrrp interface
command.
9.4.3.3
track interface
Description
With this command, you configure the tracking of interfaces.
When the link of one or more tracked interfaces changes from "up" to "down", the priority of
the assigned VRRP interface is reduced. When the link of the interface changes back from
"down" to "up", the original priority of the VRRP interface is restored.
Note
This command is available only with layer 3.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English