Siemens SCALANCE XM-400 - System Contact

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
89
The parameters have the following meaning:
Parameter
Description
Range of values / note
off
PROFINET is disabled. If a PROFINET connection is established; in
other words the PROFINET AR status is
"Online", you cannot disable PROFINET.
on
PROFINET is activated. When PROFINET is turned on, EtherNet/IP
is turned off. The switchover from
PROFINET and EtherNet/IP has no effect on
DCP.
Result
PROFINET is enabled or disabled after the next restart.
Further notes
You display the current PROFINET configuration with the show pnio command.
You restore the default settings of the PROFINET profile with the
restart command.
3.1.12.10
system contact
Description
With this command, you enter contact information for the system.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
system contact <contact info>
The parameter has the following meaning:
Parameter
Description
Range of values / note
contact info
Input box for contact information
max. 255 characters
Result
The contact information is created in the system.