Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.5 DHCP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
358 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameter assignment:
pool-enable
Result
The setting is enabled.
Note
If the IPv4 address band is enabled, the following parameters can no longer be edited:
•
DHCP options (option ...)
•
Port Range (ports)
•
Relay Agent Information (relay-information)
•
Static Leases (
static-lease
)
Further notes
You display the setting with the show ip dhcp-server pools command.
You disable the setting with the
no pool-enable command.
7.5.3.7
no pool-enable
Description
With this command you specify that this IPv4 address band will not be used.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
no pool-enable
Result
The setting is disabled.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English