Siemens SCALANCE XM-400 - No Dot1 X Guest-Vlan; Dot1 X Guest-Vlan Vlan-ID

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
871
Further notes
You also need to enable the guest VLAN function for the device. You do this with the dot1x
guest-vlan
command in the Global configuration mode.
You disable the function with the
no dot1x guest-vlan command.
You display this setting and other information with the show dot1x command.
11.7.3.2
no dot1x guest-vlan
Description
With this command, you disable the guest VLAN function for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x guest-vlan
Result
The guest VLAN function is disabled for the device.
Further notes
You enable the function with the dot1x guest-vlan command.
You display this setting and other information with the show dot1x command.
11.7.3.3
dot1x guest-vlan vlan-id
Description
With this command, you configure a guest VLAN for a port.
The port can only be assigned to the VLAN, if the VLAN has been created on the device.
Otherwise Authentication is rejected.