Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
655
Number of the addressed VLAN
Type of interface Specify a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Interface tracking is deleted.
You configure an interface tracking with the track interface command.
You display the configured interface tracking with the
show vrrp track command.
With this command you define how many tracked interfaces need to change to the "down"
status, before the priority of the assigned VRRP interface is changed.
Note
This command is available only with layer 3.
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3)#
Call up the command with the following parameters:
track <group-index> links <links-to-track(1-255)>
The parameters have the following meaning:
ID of the interface tracking
To Next Page
Loading...
Need help?
General