Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
216 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The PVID is configured
Further notes
You can reset the setting to the default with the no switchport pvid command.
You configure the VLAN ID with the
switchport access vlan command.
You display the setting and other information with the
show vlan port config command.
6.1.3.21
no switchport pvid
Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport pvid
Result
The setting is reset to the default value.
Further notes
You configure the setting with the switchport pvid command.
You configure the VLAN ID with the
switchport access vlan command.
You can display the status of this function and other information with the
show vlan port
config
command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English