Siemens SCALANCE XM-400 - Commands in the Global Configuration Mode; Router Vrrp3

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
649
Syntax
Call the command without parameter assignment:
show vrrp3 track
Result
The configured interface tracking is displayed.
9.5.3
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
9.5.3.1
router vrrp3
Description
With this command, you enable routing with VRRPv3 and change to the VRRP3 Router
configuration mode.
Note
This command is available only with layer 3.
Requirement
● IPv6 routing is enabled.
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
router vrrp3