Siemens SCALANCE XM-400 - No Snmp View

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
412 Configuration Manual, 06/2016, C79000-G8976-C252-11
7.8.2.23
no snmp view
Description
With this command, you delete an SNMP view.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp view <ViewName> <OIDTree>
The parameters have the following meaning:
Parameter
Description
Range of values / note
ViewName
Name of the view
max. 32 characters
OIDTree
Object ID
Path information of the MIB tree
Result
The SNMP view is deleted.
Further notes
You configure a view with the snmp view command.
You display the configured view trees with the
show snmp viewtree command.