Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
456 Configuration Manual, 06/2016, C79000-G8976-C252-11
Call up the command with the following parameters:
ip igmp version {1 | 2 | 3}
The parameters have the following meaning:
Version 2 Default
The version of IGMP used by the device is specified.
You can reset the version to the default with the no ip igmp version command.
You display the setting and other information with the
show ip igmp global-config
command.
no ip igmp version
Description
With this command, you reset the IGMP version back to the default value.
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Call the command without parameter assignment:
no ip igmp version
The version is reset.
You configure the IGMP version with the ip igmp version command.
You display the setting and other information with the
show ip igmp global-config
command.
To Next Page
Loading...
Need help?
General