Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.1 GARP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
433
Requirement
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
Syntax
Call the command without parameters:
gmrp
Result
In the Global configuration mode: The GMRP function is enabled on the device.
In the Interface configuration mode: The GMRP function is enabled for this interface.
Further notes
You need to enable GMRP globally for this device before you enable GMRP for individual
interfaces.
If you want to enable or disable the function for a specific interface on the device, use the
no
gmrp
command in the Interface configuration mode.
You can display the status of this function and other information with the
show vlan device
info
command.
8.1.2.2
no gmrp
Description
With this command, you disable the GMRP function for all or individual interfaces on the
device.
Requirement
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English