Siemens SCALANCE XM-400 - No Alias

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
93
Syntax
Call up the command with the following parameters:
alias <interface-name>
The parameter has the following meaning:
Parameter
Description
Range of values / note
interface-name
Name of the interface
max. 63 characters
Result
The interface was assigned a name.
Further notes
You delete the name of the interface with the no alias command.
3.1.13.2
no alias
Description
With this command, you delete the name of the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no alias
Result
The name of the interface is removed.
Further notes
You configure the name of the interface with the alias command.