Siemens SCALANCE XM-400 - No Ports

Network protocols
7.5 DHCP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
360 Configuration Manual, 06/2016, C79000-G8976-C252-11
Further notes
You disable the ports with the no ports command.
You display the setting with the
show ip dhcp-server pools command.
You enable the IPv4 address band with the
pool-enable command.
7.5.3.9
no ports
Description
With this command you disable the ports via which the IPv4 addresses of an address band
in the local subnet are assigned.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no ports [<interface-type> <0/a-b, 0/c, ...>] [<interface-type> <0/a-b, 0/c, ...>]
[all]
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface-type
Type or speed of the interface
Enter a valid interface
0/a-b,0/c,...
Port no. of the interface
all
All ports will be disabled.
-
For information on identifiers of addresses and interfaces, refer to the section "Auto-
Hotspot".
Result
The selected ports will be disabled.
Further notes
You enable the ports with the ports command.
You display the setting with the
show ip dhcp-server pools command.
You enable the IPv4 address band with the
pool-enable command.