Siemens SCALANCE XM-400 - Snmp Group

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
399
Syntax
Call the command without parameters:
no snmp engineid migrate
Result
The SNMPv3 user migration is disabled.
Further notes
You enable the SNMPv3 user migration with the snmp engineid migrate command.
7.8.2.10
snmp group
Description
With this command, you configure the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp group <GroupName> user <UserName> security-model {v1|v2c|v3}
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
GroupName
Name of the group
max. 32 characters
user
Keyword for the user name
-
UserName
Name of the user
max. 32 characters
security-model
specifies which security settings will be
used
•
v1
•
v2c
•
v3