Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
651
Commands in the VRRP3 Router configuration mode
This section describes commands that you can call up in the VRRP3 Router configuration
mode.
In the Global configuration mode, enter the
router vrrp3 command to change to this mode.
● If you exit the VRRP3 Router configuration mode with the
exit command, you return to
the Global configuration mode.
● If you exit the VRRP3 Router configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you decide the interface for which you want to assign parameters in the
VRRP3 Router configuration mode.
There you can edit the settings for a VRRP3 interface. You select the VRRP3 interface with
the parameters of this command.
Note
This command is available only with layer 3.
You are in the VRRP3 Router configuration mode.
The command prompt is as follows:
cli (config-vrrp-v3)#
Call up the command with the following parameters:
interface vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
To Next Page
Loading...
Need help?
General