Siemens SCALANCE XM-400 - Ipv6 Rip

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
706 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ipv6 rip default-information
Result
The function is disabled.
Further notes
You enable IPv6 with the ipv6 enable command.
You enable the function with the
ipv6 rip default-information originate command.
9.7.4.3
ipv6 rip
Description
This command enables RIPng routing on the interface.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 rip
Result
RIPng routing is enabled.